|
|
FO-Repeater
Converter from ISO 11898 to fiber optic cable
 The FO Repeater is used for the conversion of the CAN-signal from copper wire (ISO 11898-2) to fiber optic cables. This provides a complete isolation and protection against EM-influences.
One special feature of the Repeater is that it separates a defective segment from the rest of the network so that the remaining network can continue working. After elimination of the defect, the segment is switched into the network again.
|
Technical Data | Display | Sending (2 green LEDs), defective segment (2 red LEDs) | | CAN bus interface | ISO 11898-2. Screw terminals. CAN termination resistors are integrated (switchable). | | FOC connection | 2 x F-SMA or ST terminals for duplex line (Glass 50/125 µm duplex) | | Baudrate | Up to 888 kbps | | Delay | ~300 ns (translates into ~60 m (~90 ft.) bus length) between the wire connection of a FO Repeater through the fiber optic cable to the wire connection of a second FO Repeater (not including the signal delay time of the fiber optics, which is ~5 ns/m) | | Power supply | 9-35 V DC, 3 W typ., through terminals | | Temperature range | -20 ºC to +60 ºC | | Housing, size | Plastic enclosure, 110 x 75 x 22 mm (without FO connector) |
|
Contents of delivery
- FO-Repeater, Quick reference
Order number
| 1.01.0063.01010 |
CAN Fiber Optic Repeater - Glass fiber version with F-SMA connector |
| 1.01.0063.01020 |
CAN Fiber Optic Repeater - Glass fiber version with ST connector | |
|
|
|
)
